1/*	$NetBSD: nsphyterreg.h,v 1.4 2005/12/11 12:22:42 christos Exp $	*/
2
3/*-
4 * Copyright (c) 1999, 2001 The NetBSD Foundation, Inc.
5 * All rights reserved.
6 *
7 * This code is derived from software contributed to The NetBSD Foundation
8 * by Jason R. Thorpe of the Numerical Aerospace Simulation Facility,
9 * NASA Ames Research Center.
10 *
11 * Redistribution and use in source and binary forms, with or without
12 * modification, are permitted provided that the following conditions
13 * are met:
14 * 1. Redistributions of source code must retain the above copyright
15 *    notice, this list of conditions and the following disclaimer.
16 * 2. Redistributions in binary form must reproduce the above copyright
17 *    notice, this list of conditions and the following disclaimer in the
18 *    documentation and/or other materials provided with the distribution.
19 *
20 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
21 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
22 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
23 * PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
24 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
25 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
26 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
27 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
28 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
29 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
30 * POSSIBILITY OF SUCH DAMAGE.
31 *
32 * $FreeBSD$
33 */
34
35#ifndef _DEV_MII_NSPHYTERREG_H_
36#define	_DEV_MII_NSPHYTERREG_H_
37
38/*
39 * DP83843 registers; We also have the MacPHYTER (DP83815) internal
40 * PHY register definitions here, since the two are, for our purposes,
41 * compatible.
42 */
43
44#define	MII_NSPHYTER_PHYSTS	0x10	/* PHY status */
45#define	PHYSTS_REL		0x8000	/* receive error latch */
46#define	PHYSTS_CIML		0x4000	/* CIM latch */
47#define	PHYSTS_FCSL		0x2000	/* false carrier sense latch */
48#define	PHYSTS_DEVRDY		0x0800	/* device ready */
49#define	PHYSTS_PGRX		0x0400	/* page received */
50#define	PHYSTS_ANEGEN		0x0200	/* autoneg. enabled */
51#define	PHYSTS_MIIINTR		0x0100	/* MII interrupt */
52#define	PHYSTS_REMFAULT		0x0080	/* remote fault */
53#define	PHYSTS_JABBER		0x0040	/* jabber detect */
54#define	PHYSTS_NWAYCOMP		0x0020	/* NWAY complete */
55#define	PHYSTS_RESETSTAT	0x0010	/* reset status */
56#define	PHYSTS_LOOPBACK		0x0008	/* loopback status */
57#define	PHYSTS_DUPLEX		0x0004	/* full duplex */
58#define	PHYSTS_SPEED10		0x0002	/* speed == 10Mb/s */
59#define	PHYSTS_LINK		0x0001	/* link up */
60	/* Below are the MacPHYTER bits that are different. */
61#define	PHYSTS_MP_REL		0x2000	/* receive error latch */
62#define	PHYSTS_MP_POLARITY	0x1000	/* polarity inverted */
63#define	PHYSTS_MP_FCSL		0x0800	/* false carrier sense latch */
64#define	PHYSTS_MP_SIGNAL	0x0400	/* signal detect */
65#define	PHYSTS_MP_DESCRLK	0x0200	/* de-scrambler lock */
66#define	PHYSTS_MP_PGRX		0x0100	/* page received */
67#define	PHYSTS_MP_MIIINTR	0x0080	/* MII interrupt */
68#define	PHYSTS_MP_REMFAULT	0x0040	/* remote fault */
69#define	PHYSTS_MP_JABBER	0x0020	/* jabber detect */
70#define	PHYSTS_MP_NWAYCOMP	0x0010	/* NWAY complete */
71
72
73#define	MII_NSPHYTER_MIPSCR	0x11	/* MII interrupt PHY specific
74					   control */
75
76#define	MIPSCR_INTEN		0x0002	/* interrupt enable */
77#define	MIPSCR_TINT		0x0001	/* test interrupt */
78
79
80#define	MII_NSPHYTER_MIPGSR	0x12	/* MII interrupt PHY generic
81					   status */
82#define	MIPGSR_MINT		0x8000	/* MII interrupt pending */
83	/* The bits below are MacPHYTER only. */
84#define	MIPGSR_MSK_LINK		0x4000	/* mask link status event */
85#define	MIPGSR_MSK_JAB		0x2000	/* mask jabber event */
86#define	MIPGSR_MSK_RF		0x1000	/* mask remote fault event */
87#define	MIPGSR_MSK_ANC		0x0800	/* mask auto-neg complete event */
88#define	MIPGSR_MSK_FHF		0x0400	/* mask false carrier half full event */
89#define	MIPGSR_MSK_RHF		0x0200	/* mask RX error half full event */
90
91#define	MII_NSPHYTER_DCR	0x13	/* Disconnect counter */
92
93#define	MII_NSPHYTER_FCSCR	0x14	/* False carrier sense counter */
94
95#define	MII_NSPHYTER_RECR	0x15	/* Receive error counter */
96
97
98#define	MII_NSPHYTER_PCSR	0x16	/* PCS configuration and status */
99#define	PCSR_SINGLE_SD		0x8000	/* single-ended SD mode */
100#define	PCSR_FEFI_EN		0x4000	/* far end fault indication mode */
101#define	PCSR_DESCR_TO_RST	0x2000	/* reset descrambler timeout counter */
102#define	PCSR_DESCR_TO_SEL	0x1000	/* descrambler timer mode */
103#define	PCSR_DESCR_TO_DIS	0x0800	/* descrambler timer disable */
104#define	PCSR_LD_SCR_SD		0x0400	/* load scrambler seed */
105#define	PCSR_TX_QUIET		0x0200	/* 100Mb/s transmit true quiet mode */
106#define	PCSR_TX_PATTERN		0x0180	/* 100Mb/s transmit test pattern */
107#define	PCSR_F_LINK_100		0x0040	/* force good link in 100Mb/s */
108#define	PCSR_CIM_DIS		0x0020	/* carrier integrity monitor disable */
109#define	PCSR_CIM_STATUS		0x0010	/* carrier integrity monitor status */
110#define	PCSR_CODE_ERR		0x0008	/* code errors */
111#define	PCSR_PME_ERR		0x0004	/* premature end errors */
112#define	PCSR_LINK_ERR		0x0002	/* link errors */
113#define	PCSR_PKT_ERR		0x0001	/* packet errors */
114	/* Below are the MacPHYTER bits that are different. */
115#define	PCSR_MP_BYP_4B5B	0x1000	/* bypass encoder */
116#define	PCSR_MP_FREE_CLK	0x0800	/* free funning RX clock */
117#define	PCSR_MP_TQ_EN		0x0400	/* enable True Quiet mode */
118#define	PCSR_MP_SD_FORCE_B	0x0200	/* force signal detection */
119#define	PCSR_MP_SD_OPTION	0x0100	/* enhanced signal detection alg. */
120#define	PCSR_MP_NRZI_BYPASS	0x0004	/* NRZI bypass enabled */
121
122
123	/* The bits below are not on MacPHYTER. */
124#define	MII_NSPHYTER_LBR	0x17	/* loopback and bypass */
125#define	LBR_BP_STRETCH		0x4000	/* bypass LED stretching */
126#define	LBR_BP_4B5B		0x2000	/* bypass encoding/decoding */
127#define	LBR_BP_SCR		0x1000	/* bypass scrambler/descrambler */
128#define	LBR_BP_RX		0x0800	/* bypass receive function */
129#define	LBR_BP_TX		0x0400	/* bypass transmit function */
130#define	LBR_100_DP_CTL		0x0380	/* 100Mb/s data patch control */
131#define	LBR_TW_LBEN		0x0020	/* TWISTER loopback enable */
132#define	LBR_10_ENDEC_LB		0x0010	/* 10Mb/s ENDEC loopback */
133
134
135	/* The bits below are not on MacPHYTER. */
136#define	MII_NSPHYTER_10BTSCR	0x18	/* 10baseT status and control */
137#define	BTSCR_AUI_TPI		0x2000	/* TREX operating mode */
138#define	BTSCR_RX_SERIAL		0x1000	/* 10baseT RX serial mode */
139#define	BTSCR_TX_SERIAL		0x0800	/* 10baseT TX serial mode */
140#define	BTSCR_POL_DS		0x0400	/* polarity detection and correction
141					   disable */
142#define	BTSCR_AUTOSW_EN		0x0200	/* AUI/TPI autoswitch */
143#define	BTSCR_LP_DS		0x0100	/* link pulse disable */
144#define	BTSCR_HB_DS		0x0080	/* heartbeat disabled */
145#define	BTSCR_LS_SEL		0x0040	/* low squelch select */
146#define	BTSCR_AUI_SEL		0x0020	/* AUI select */
147#define	BTSCR_JAB_DS		0x0010	/* jabber disable */
148#define	BTSCR_THIN_SEL		0x0008	/* thin ethernet select */
149#define	BTSCR_TX_FILT_DS	0x0004	/* TPI receive filter disable */
150
151
152#define	MII_NSPHYTER_PHYCTRL	0x19	/* PHY control */
153#define	PHYCTRL_TW_EQSEL	0x3000	/* TWISTER e.q. select */
154#define	PHYCTRL_BLW_DS		0x0800	/* TWISTER base line wander disable */
155#define	PHYCTRL_REPEATER	0x0200	/* repeater mode */
156#define	PHYCTRL_LED_TXRX_MODE	0x0180	/* LED TX/RX mode */
157#define	PHYCTRL_LED_DUP_MODE	0x0040	/* LED DUP mode */
158#define	PHYCTRL_FX_EN		0x0020	/* Fiber mode enable */
159#define	PHYCTRL_PHYADDR		0x001f	/* PHY address */
160	/* Below are the MacPHYTER bits that are different. */
161#define	PHYCRTL_MP_PSR_15	0x0800	/* BIST sequence select */
162#define	PHYCTRL_MP_BIST_STAT	0x0400	/* BIST passed */
163#define	PHYCTRL_MP_BIST_START	0x0200	/* start BIST */
164#define	PHYCTRL_MP_BP_STRETCH	0x0100	/* bypass LED stretching */
165#define	PHYCTRL_MP_PAUSE_STS	0x0080	/* pause status */
166
167
168	/* The bits below are MacPHYTER only. */
169#define	MII_MACPHYTER_TBTCTL	0x1a	/* 10baseT Control */
170#define	TBTCTL_LOOPBACK_10_DIS	0x0100	/* loopback 10Mb/s disable */
171#define	TBTCTL_LP_DIS		0x0080	/* link pulse disable */
172#define	TBTCTL_FORCE_LINK_10	0x0040	/* force 10Mb/s link good */
173#define	TBTCTL_FORCE_POL_COR	0x0020	/* force polarity correction */
174#define	TBTCTL_INV_POLARITY	0x0010	/* inverted polarity */
175#define	TBTCTL_AUTOPOL_DIS	0x0008	/* auto-polarity disable */
176#define	TBTCTL_HEARTBEAT_DIS	0x0002	/* heartbeat disable */
177#define	TBTCTL_JABBER_DIS	0x0001	/* jabber disable */
178
179#endif /* _DEV_MII_NSPHYTERREG_H_ */
180