1start-autoinstall - HELP
2-----------------------------------------------
3
4About:
5	start-autoinstall is used when performing automated installationsr. It is able
6	to configure networking with provided settings, and fetch an installation script from
7	http / ftp server. This allows media to be created which fetches dynamic configuration
8	options from a server-side supplier. 
9
10Usage:
11	pc-sysinstall start-autoinstall <config>
12
13Config Syntax:
14
15	The configuration file for start-autoinstall can contain the following options:
16
17	pc_config: <value>
18		- Location of the pc-sysinstall installation configuration file, can be local
19		  or start with http:// or ftp:// to fetch from a remote system. 
20
21     shutdown_cmd: <value>
22		- Command to execute post-installation, such as "shutdown -p now" or other.
23
24  confirm_install: (YES/NO)
25		- Prompt on the console to begin installation. Defaults to YES.
26		  Warning: Setting this to NO will start an installation as soon as start-autoinstall
27		  is run. (I.E. after booting some install media) It may be dangerous if a disk is left
28		  in a drive and the system is turned on!
29
30       nic_config: (DHCP-ALL / <cfg>)
31		- When set to DHCP-ALL, the software will attempt to get a network address from DHCP on
32		  any / all detected NICS. If set to some other command, it will be used as an argument
33		  to "ifconfig" to enable networking. 
34
35	  nic_dns: <value>
36		- Use the following DNS server for networking
37		
38      nic_gateway: <gateway>
39		- Use the following default route / gateway for networking
40