Revert r330897:

This was intended to be a non-functional change. It wasn't. The commit
message was thus wrong. In addition it broke arm, and merged crypto
related code.

Revert with prejudice.

This revert skips files touched in r316370 since that commit was since
MFCed. This revert also skips files that require $FreeBSD$ property
changes.

Thank you to those who helped me get out of this mess including but not
limited to gonzo, kevans, rgrimes.

Requested by: gjb (re)

Partial merge of the SPDX changes

These changes are incomplete but are making it difficult
to determine what other changes can/should be merged.

No objections from: pfg

Copy head@r302406 to stable/11 as part of the 11.0-RELEASE cycle.
Prune svn:mergeinfo from the new branch, as nothing has been merged
here.

Additional commits post-branch will follow.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Whitespace fixes for files in sys/mips/nlm

Clean up whitespace issues under sys/mips/nlm (except dev). No
functional change in this commit.

Improve additional interrupt ACK for Broadcom XLP

Handling some interrupts in XLP (like PCIe and SATA) involves writing to
vendor specific registers as part of interrupt acknowledgement.

This was earlier done with xlp_establish_intr(), but a better solution
is to provide a function xlp_set_bus_ack() that can be used with
cpu_establish_hardintr(). This will allow platform initialization code to
setup these ACKs without changing the standrard drivers.

Remove run-time allocation of XLP IRQs

Follow the same static IRQ to Interrupt Table Entry mapping as the other
OS supported on XLP.

Fix up interrupt definitions for Broadcom XLP

Gather all the IRQ definitions to interrupt.h. Earlier these were in xlp.h
and pic.h. Update the definition of XLP_IRQ_IS_PICINTR to check for last
irq as well.

MIPS XLP platform code update.

* Update the hardware access register definitions and functions to bring
them in line with other Netlogic software.
* Update the platform bus to use PCI even for on-chip devices. Add a dummy
PCI driver to ignore on-chip devices which do not need driver.
* Provide memory and IRQ resource allocation code for on-chip devices
which cannot get it from PCI config.
* add support for on-chip PCI and USB interfaces.
* update conf files, enable pci and retain old MAXCPU until we can support
>32 cpus.

Approved by: re(kib), jmallett

Add MIPS platform files for Netlogic XLP SoC.

Processor, UART, PIC and Messaging Network code. Also add
sys/mips/nlm/hal for on-chip device registers.

In collaboration with: Prabhath Raman <prabhathpr at netlogicmicro com>

Approved by: bz(re), jmallett, imp(mips)