- Copy stable/10 (r259064) to releng/10.0 as part of the
10.0-RELEASE cycle.
- Update __FreeBSD_version [1]
- Set branch name to -RC1

[1] 10.0-CURRENT __FreeBSD_version value ended at '55', so
start releng/10.0 at '100' so the branch is started with
a value ending in zero.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

The T5 allows the driver to specify the ISS. Do so; use the ISS picked
by the kernel.

MFC after: 1 day

cxgbe(4): Add support for Chelsio's Terminator 5 (aka T5) ASIC. This
includes support for the NIC and TOE features of the 40G, 10G, and
1G/100M cards based on the T5.

The ASIC is mostly backward compatible with the Terminator 4 so cxgbe(4)
has been updated instead of writing a brand new driver. T5 cards will
show up as cxl (short for cxlgb) ports attached to the t5nex bus driver.

Sponsored by: Chelsio

cxgbe(4): Ask the card's firmware to pad up tiny CPLs by encapsulating
them in a firmware message if it is able to do so. This works out
better for one of the FIFOs in the chip.

MFC after: 5 days

Add a couple of missing error codes. Treat CPL_ERR_KEEPALV_NEG_ADVICE as
negative advice and not a fatal error.

MFC after: 3 days

Support for TCP DDP (Direct Data Placement) in the T4 TOE module.

Basically, this is automatic rx zero copy when feasible. TCP payload is
DMA'd directly into the userspace buffer described by the uio submitted
in soreceive by an application.

- Works with sockets that are being handled by the TCP offload engine
of a T4 chip (you need t4_tom.ko module loaded after cxgbe, and an
"ifconfig +toe" on the cxgbe interface).
- Does not require any modification to the application.
- Not enabled by default. Use hw.t4nex.<X>.toe.ddp="1" to enable it.

Allow for a different handler for each type of firmware message.

MFC after: 2 weeks

cxgbe(4): update to firmware interface 1.5.2.0; updates to shared code.

cxgbe(4) - NIC driver for Chelsio T4 (Terminator 4) based 10Gb/1Gb adapters.

MFC after: 3 weeks