| #
192923 |
|
27-May-2009 |
bms |
Merge final round of MLD changes from p4:
ip6_input.c, in6.h:
* Add netinet6-specific mbuf flag M_RTALERT_MLD, shadowing M_PROTO6.
* Always set this flag if HBH Router Alert option is present for MLD,
even when not forwarding.
icmp6.c:
* In icmp6_input(), spell m->m_pkthdr.rcvif as ifp to be consistent.
* Use scope ID for verifying input. Do not apply SSM filters here, no inpcb.
* Check for M_RTALERT_MLD when validating MLD traffic, as we can't see
IPv6 hop options outside of ip6_input().
in6_mcast.c:
* Use KAME scope/zone ID in in6_multi.
* Update net.inet6.ip6.mcast.filters implementation to use scope IDs
for comparisons.
* Fix scope ID treatment in multicast socket option processing.
Scope IDs passed in from userland will be ignored as other less
ambiguous APIs exist for specifying the link.
* Tighten userland input checks in IPv6 SSM delta and full-state ops.
* Source filter embedded scope IDs need to be revisited, for now
just clear them and ignore them on input.
* Adapt KAME behaviour of looking up the scope ID in the default zone
for multicast leaves, when the interface is ambiguous.
mld6.c:
* Tighten origin checks on MLD traffic as per RFC3810 Section 6.2:
* ip6_src MAY be the unspecified address for MLDv1 reports.
* ip6_src MAY have link-local address scope for MLDv1 reports,
MLDv1 queries, and MLDv2 queries.
* Perform address field validation *before* accepting queries.
* Use KAME scope/zone ID in query/report processing.
* Break const correctness for mld_v1_input_report(), mld_v1_input_query()
as we temporarily modify the input mbuf chain.
* Clear the scope ID before handoff to userland MLD daemon.
* Fix MLDv1 old querier present timer processing.
With the protocol defaults, hosts should revert to MLDv2 after 260s.
* Add net.inet6.mld.v1enable sysctl, default to on.
ifmcstat.c:
* Use sysctl by default; -K requests kvm(3) if so compiled.
mld.4:
* Connect man page to build.
Tested using PCS.
|