omap3-panel-sharp-ls037v7dw01.dtsi revision 284090 
1/*
2 * Common file for omap dpi panels with QVGA and reset pins
3 *
4 * Note that the board specifc DTS file needs to specify
5 * at minimum the GPIO enable-gpios for display, and
6 * gpios for gpio-backlight.
7 */
8
9/ {
10	aliases {
11		display0 = &lcd0;
12	};
13
14	backlight0: backlight {
15		compatible = "gpio-backlight";
16		default-on;
17	};
18
19	/* 3.3V GPIO controlled regulator for LCD_ENVDD */
20	lcd_3v3: regulator-lcd-3v3 {
21		compatible = "regulator-fixed";
22		regulator-name = "lcd_3v3";
23		regulator-min-microvolt = <3300000>;
24		regulator-max-microvolt = <3300000>;
25		startup-delay-us = <70000>;
26	};
27
28	lcd0: display {
29		compatible = "sharp,ls037v7dw01";
30		label = "lcd";
31		power-supply = <&lcd_3v3>;
32
33		port {
34			lcd_in: endpoint {
35				remote-endpoint = <&dpi_out>;
36			};
37		};
38	};
39};
40
41/* Needed to power the DPI pins */
42&vpll2 {
43	regulator-always-on;
44};
45
46&dss {
47	status = "ok";
48	port {
49		dpi_out: endpoint {
50			remote-endpoint = <&lcd_in>;
51			data-lines = <18>;
52		};
53	};
54};
55
56&mcspi1 {
57	tsc2046@0 {
58		reg = <0>;			/* CS0 */
59		compatible = "ti,tsc2046";
60		spi-max-frequency = <1000000>;
61		vcc-supply = <&lcd_3v3>;
62		ti,x-min = /bits/ 16 <0>;
63		ti,x-max = /bits/ 16 <8000>;
64		ti,y-min = /bits/ 16 <0>;
65		ti,y-max = /bits/ 16 <4800>;
66		ti,x-plate-ohms = /bits/ 16 <40>;
67		ti,pressure-max = /bits/ 16 <255>;
68		ti,swap-xy;
69		linux,wakeup;
70	};
71};
72