Lines Matching refs:rate
351 * Install default tx rate handling: no fixed rate, lowest
352 * supported rate for mgmt and multicast frames. Default
366 * Setting the management rate to MCS 0 assumes that the
367 * BSS Basic rate set is empty and the BSS Basic MCS set
371 * defined rate for this mode.
557 const uint8_t *buf, int len, int rate, int rssi)
614 if (rate >= 0)
615 printf(" %dM", rate / 2);
656 * Workaround awkwardness with fixed rate. We are called
657 * to check both the legacy rate set and the HT rate set
658 * but we must apply any legacy fixed rate check only to the
659 * legacy rate set and vice versa. We cannot tell what type
660 * of rate set we've been given (legacy or HT) but we can
661 * distinguish the fixed rate type (MCS have 0x80 set).
663 * check MCS or legacy rate using the flags and we use the
664 * type of any fixed rate to avoid applying an MCS to a
665 * legacy rate and vice versa.
680 * we must use the appropriate basic rate set or chaos will
708 * Check for fixed rate.
719 * A rate in the node's rate set is not
720 * supported. If this is a basic rate and we
722 * Otherwise we just discard/ignore the rate.
729 * Overwrite with the supported rate
730 * value so any basic rate bit is set.
1271 * Check if the specified rate set supports ERP.
1272 * NB: the rate set is assumed to be sorted.
1298 * Mark the basic rates for the rate table based on the
1339 * Set the basic rates in a rate set.
1349 * Add basic rates to a rate set.