Lines Matching defs:code
2826 * advertise these capabilities. Thus this code
3289 * Yes, the rate control code doesn't know these are A-MPDU
3351 switch (calib->code) {
3383 calib->code);
3387 "saving calibration result idx=%d, code=%d len=%d\n", idx, calib->code, len);
3922 * Mark the entry so the above code will check it
4440 * The original driver code only enabled protection for OFDM rates.
4882 cmd->code = IWN_CMD_TX_DATA;
5241 iwn_cmd(struct iwn_softc *sc, int code, const void *buf, int size, int async)
5287 cmd->code = code;
5298 __func__, iwn_intr_str(cmd->code), cmd->code,
6096 cmd.code = IWN4965_PHY_CALIB_DIFF_GAIN;
6111 cmd.code = sc->reset_noise_gain;
6135 cmd.code = IWN4965_PHY_CALIB_DIFF_GAIN;
6167 cmd.code = sc->noise_gain;
7155 * Build a probe request frame. Most of the following code is a
7552 int code, int baparamset, int batimeout)
7561 if (code == IEEE80211_STATUS_SUCCESS) {
7571 return sc->sc_addba_response(ni, tap, code, baparamset, batimeout);
7866 cmd.code = IWN5000_PHY_CALIB_CRYSTAL;
7882 cmd.code = IWN5000_PHY_CALIB_TEMP_OFFSET;
7900 cmd.code = IWN5000_PHY_CALIB_TEMP_OFFSET;
8092 * The firmware boot code is small and is intended to be copied directly into
8161 /* Load firmware boot code. */
9159 * Translate CSR code to string